× Have an issue with your etracer software or hardware? Please post your question(s) here...

Irregular curve spacing

Start
Prev
1
Next
End

Brennwald
Topic Author
Offline
New Member

4 years 8 months ago #74 by Brennwald

Irregular curve spacing was created by Brennwald

I don't follow the discussions around here very often, so I don't know if this is a known issue, but...

When I measured some 6H30P triodes a while ago, I observed a strange "jump" in the curves. The spacing between the -10 V and -11 V curves is a bit bigger than with the remaining curves. I always thought that this is an issue with my tubes. However, when I repeated the measurement with a different curve tracera different curve tracer today, I did not observe the issue. Is this a known artifact of the eTracer?

(see attached curves from eTracer and PyPSUcurvetrace)

Please Log in or Create an account to join the conversation.

admin
Offline
Administrator

4 years 3 months ago #79 by admin

Replied by admin on topic Irregular curve spacing

Sorry I missed your post. This small gap is cased by the the gain setting switched from high gain mode to low gain mode. The error (about 1%) is well within the design spec but sometimes it's noticeable on the plot. I've made some changes to the firmware to mitigate the problem. I will contact you and we might need to work on a remote debug session.

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.037 seconds

Irregular curve spacing

Attachments:

Older Posts

Most Read Posts

Login Form