Enabling Sbox12 via Etracer Software Configuration

Dear All,

I have just built the etracer & sbox 12 combination and all the hardware appears to be working correctly.
I am accessing using Windows 11 Pro and the software loads and both the etracer & sbox are detected and function.

When using the etracer configuration drop down window, the window does not include the 2 bottom lines "Arguments" and "Enable Sbox12"?

The Sbox will hence not automatically configure the tube pin configuration connection after the tube configuration file is selected.

I am running the latest downloaded stable etracer_v2.0.17.exe version, not the alternate Alpha version.

I had some windows scaling problems which truncated the bottom of the etracer window, but have resolved these and the etracer window is fully visible but the drop-down configuration window is missing the 2 bottom lines "Ärguments" and "Enable Sbox12"?

Any advice / guidance would be appreciated.

Thankyou.

Solution

I have since determined that the above features are included in the etracer_v2.1.42 alpha software.
I assume this has been included since the software v2.1 release.
The initially did not use the v2.1.42 software due to the "älpha" label wrongly assuming it was not stable.